[Editor's Note: This is Part 2 of 2, originally published at GreenOptions.com.]
Electricity, or how I saved over $500 this winter
You may recall in Part 1 on Natural Gas, I outlined how I saved $166 on my natural gas bills over a two month period versus the previous homeowner (standardized against winter temperature differences) with little to no effort and less than $100 in supplies. That number has now increased to over $400 in savings from September 2006 through March 2007…
Now I’m happy to report that I got the electricity data on the previous owner as well, and frankly I’m not sure how she used so much electricity in our little house – she used as much in one month as we expect to use in a whole year. But the data doesn’t lie and over the same 6 month winter time period, i.e. no air conditioners or dehumidifiers to skew the data, we have saved an astonishing $516 over her previous bills in the same 6 months the year before…Our monthly bills are $25-$35 in the DC metropolitan area (we’re paying 13 cents/kWh on average). It’s incredible how easy it is to save electricity, money, and pollution.
As before, your first thought must be that I’m sitting in the dark or bought all new appliances. Nope. The porch light greets us when we come home, we hang out in various rooms in the evening without much thought to turning the lights off, and we haven’t replaced any major appliances (same refrigerator, dishwasher, laundry, etc).
Here are my secrets, not exactly rocket science, which cost less than $100 and only a little effort:
- Replaced all lights with CFLs – Every one. The light is the same. They hardly burn out. Friends can’t tell the difference. The trick? Don’t buy the $2 cheapie and expect it to put out the save amount of light. Pay $3 for the one with the most lumens, i.e. the 100 watt replacement (use these where the bulb won’t be visible), and/or the ones with the fancy cover so it looks like a regular bulb (use these where the bulb is visible). You can get really small ones and specialty ones for vanity lights that work great. Some (not all) may take 5 seconds to warm up and reach full brightness but is that too much to ask? Prioritize the lights that are on the most (not the ones in the closet) if you don’t want to replace them all.
- Light sensor on the front porch – I don’t like to come home to a dark porch. So I paid $10 for a light sensing socket and screwed it into the old socket on the porch. Sun goes down, light comes on, and it has a timer to turn itself off after 2, 4, 6 hours (or the next morning).
- Phantom Loads – There are a lot of things that are “on” even when “off” – anything with a remote control, a fat box for a plug (a transformer that converts AC to DC), a clock, cell phone chargers, printers, monitors, etc. We have 2 or 3 power strips that allow me to shut off 3-4 things at once where it’s convenient, or we unplug them. But it’s not practical to do everything – I don’t like to reprogram the VCR, TV, microwave clock, etc so I don’t bother. I do unplug the clock radio in the guest room when no one’s there (that thing uses $24/yr alone) and the chargers that don’t get used everyday. Get a Kill-a-Watt
and use it to go around the house and test different appliances (or better yet, buy one with some friends and pass it around to share costs). You will be surprised how many of these you have…
That’s about it…surprisingly simple. Other things you can do:
- Switch to natural gas appliances – As you replace your old appliances (if they break or you remodel), switch to natural gas. It’s cheaper and cleaner for the most part (even with the higher natural gas prices recently) – stove, dryer, and water heater. After all, electricity production is about 30% efficient and mostly comes from coal. I found a free natural gas dryer on Craig’s List a few years ago at my old house. An electric water heater alone probably costs over $500/yr to operate – that’s more than it costs to buy it.
- Buy Energy Star appliances – As you replace your old appliances, pay a little bit more for ones with the “Energy Star” label. They are more efficient and save more money in the run. Don’t necessarily replace the appliances if they still work (although a new refrigerator over one that is 10 years or older could easily save over $100/yr). The “big four” users are refrigerator, dehumidifier, central air conditioner, and electric water heater.
- Buy a window air conditioner – We haven’t gone through a DC summer yet, but we plan on using the air conditioner at some times…but there’s no reason to cool the whole house at night, so we’ll use a window air conditioner for our room and shut the central air off. Use a fan at night if it cools down – even 4-5 use less than the air conditioner.
- Refrigerator details – Turn off the ice maker. We don’t use much ice and don’t feel the need to have 2 gallons of it available at all times, so I turn it off once it’s filled (and it usually stays off for 2-3 months actually). And if you buy a new refrigerator, the top/bottom door styles are more efficient than the side-by-side doors. Refrigerators can easily use less than 500 kWh/yr now versus 1500+ a few years ago (hurray for federal efficiency standards).
- Don’t replace the windows for energy reasons – As before, do it for aesthetics. Do it for comfort. Don’t do it expecting to save oodles of money and run from anyone who says otherwise.

April 23, 2007 at 2:18 pm |
It’s amazing how much impact any one of these steps can make – we started turning off the powerstrips of appliances with phantom load a little over a month ago, and it looks like that alone cut 1/3 off our electricity bill.
April 27, 2007 at 3:33 pm |
I was searching for “energy saving” related blogs and found your wonderful creation.
I especially like the way you are tracking your success in reducing energy usage. I shows folks that it can be done.
June 8, 2007 at 8:07 pm |
As part of my work for the Minnesota State Energy Office I have put together a presentation on “10 Ways to Save Energy in Your Home”. Your suggestions are among the ones we talk about, and all together can save the average home owner some substantial money–and dramatically reduce CO2 emissions, as well. Here are a couple more ideas that can reduce your energy bills:
Get annual maintenance on your mechanical equipment (furnace, AC, water heater) to ensure peak efficiency and safety.
Replace furnace filters regularly (monthly for the cheap ones, maybe every 3 months for the high buck ones). Reduced air flow reduces efficiency and can wear parts and systems.
A programmable thermostat lets you set you heating and cooling to what you can stand, when you are actually home and awake. Your cat will tolerate 60 degrees in the winter all day long (having the benefit of a portable blanket) and if you use central air, you can have it set so that when you come home after a hard day at the grind, it will be a tolerable temperature. And the programmable thermostat will do all the work for you; no more getting up off the couch to mess with the old mercury switch.
Outlet strips are a great idea; new ones are now available that will automatically sense loads, and shut off when there is none. This makes them perfect for cell phone chargers, battery chargers, etc.
Ditto on CFLs. They now come as dimmables, 3-ways, and in colors, too. Nothing says “party” like a soft blue CFL bulb in your dining room light.
Motion switches (indoors and out) can let you have lights on when people are there to use them. Be sure and set them up so the cat doesn’t make the light come on or the neighbor’s tree branch when the wind blows. A motion switch in a bathroom in a house full of kids will pay for itself in no time. Of course that means they get to hear the ‘Dad lament’ less often: “Why is this light on when nobody is in here?”
Get an Energy Audit (or Home Performance Review) and pop for a good one that includes a blower door test, an analysis of your energy bills, and an inspection of appliances, insulation, and ventilation systems. This is the best way to make decisions about energy improvements, rather than letting the window salesman decide for you.
ENERGY STAR is the best tool for buying stuff that nobody (mostly) knows about. If you go to their website (energystar.gov) you can do a search for almost any energy-using product you can think of and get a list of all the ones that meet the requirements, and by how much. This means not only can you find out which TV or dishwasher or furnace or DVD player is ENERGY STAR rated, you can also choose between products with slightly different numbers. That way (after plugging in your electricity cost, for example) you can decide if the extra 4 inches on that LCD screen is worth the $20/year in additional electric costs. And if you print out what you learn and bring it to the appliance store, it will make the “sales associates’ weep–which I always enjoy, personally.
Timers. Lots of things only need to be on for a little while, like that lamp in the living room that tells the burglars that you might be home. A simple timer can have it come on and off at different times every night, rather than leaving it on all night when you are off in Aruba for the weekend. And up here on the frozen tundra, a timer can make your engine block heater come on an hour before you want to start the car, rather than heating the great outdoors all night long.
Well, that’s enough for now. If anyone would actually like a copy of a pdf with the 10 tips, Solar Kismet knows where to find me…
December 2, 2007 at 4:20 pm |
A window ac unit does work, I saved about 20% on summer bills when i bought a window unit and turned off my central.